MX-Ac

Tool especially designed for tensioning wire with the whole range of MAXTENSOR® joiners and tensioners.

Manufactured in cast steel

For intensive use

Tensioning of wire
  • Easy to install: up to 70% faster than traditional joining systems.
  • The tension on the wire is produced by tensioning using the MAXTENSOR® tool.
  • Leave a minimum length of 10 cm from the free end of the wire to the outlet hole of the tensioner (see image).
Weight Load limit
 1,2 Kg
(2,6 lb)
 350Kg
(770 lb)

MAXTENSOR® MX-AC is manufactured using high tensile and durability steel, with anti-corrosion treatment, for tensioning wire with the whole range of MAXTENSOR® joiners and connectors. It combines comfort of use with great strength, being the lightest metal tool on the market. For those requiring the best performance in a tool for intensive use.

When planning the installation with Maxtensor® connectors and tensioners, you must take into account the following tips for use.

  • The range of connectors and wire tensioners are usable with many of the wires for agricultural use on trellises, fences, or support wires. Given the variety of types of wire existing in the market, it is recommended to consult the technical department of Maxtensor Internacional S.L. on which would be the most suitable product depending on the application and the type of wire used.
  • Do not use the product outside the recommended range of diameters.
  • Do not exceed the load limit of any product.
  • The indicated load limit is a static load value, and depends on the type of wire and diameter used. If you think that the product will be subject to high loads, use wire diameters close to the maximum value of the range indicated on the product. In case of doubt, it is recommended to consult the technical department of Maxtensor Internacional S.L. on which would be the most suitable product depending on the application and the type of wire used.
  • It should be taken into account that the dynamic loads produced by the wind, impacts, vibrations, can significantly increase the service loads on the wire affecting the operation of the product.
  • It should be taken into account that dirt, chemicals and insects, among others inside the product, can jeopardize the proper functioning of the device.
  • Leave a minimum length of 10 cm from the free end of the wire to the outlet hole of the product.
  • Secure free ends of excess wire.
  • Check the installation status regularly.
MAXTENSOR® catalogue Farm and livestock line (EN) – pdf 2,5 MB
MAXTENSOR® catalogue Agricultura y ganadería (ES) – pdf 2,6 MB
MAXTENSOR® catalogue Gamme agriculture et élevage (FR) – pdf 2,5 MB
Related products
mx1-WP

Line end tensioner for wire from 1.8 to 3.2 mm in diameter.

Maximum load 400 kg (880 lb).

Includes protrusion to protect the wire from being cut by the pole.

SEE FACT SHEET

MX-Fv

Tensioning tool manufactured in polymer and steel core.

For moderate use.

Recommended maximum load 150 kg

SEE FACT SHEET